Idle down pause.
Thread Starter
Senior Member
Back Marker
Joined: Dec 2017
Posts: 179
From: Quincy Mass
Idle down pause.
Hey People out there
... I have a carb issue that I know someone could advise me on.
I have modifications on the bike as you know (Stage 2 Cams, 11:1 pistons and minor carb adjustments.)
When the Idle comes down after you bleep the throttle...there is a small pause/delay at the end of the revs before it rests at normal Idle.
Is it because that the Main Jets are too heavy (180 front 185 Rear) and the fuel is still in the carbs?
Does the TPS need to be set at a different resistance than 550 ohms?
Would appreciate any thoughts out there.
Thanks.
... I have a carb issue that I know someone could advise me on.
I have modifications on the bike as you know (Stage 2 Cams, 11:1 pistons and minor carb adjustments.)
When the Idle comes down after you bleep the throttle...there is a small pause/delay at the end of the revs before it rests at normal Idle.
Is it because that the Main Jets are too heavy (180 front 185 Rear) and the fuel is still in the carbs?
Does the TPS need to be set at a different resistance than 550 ohms?
Would appreciate any thoughts out there.
Thanks.
Thread Starter
Senior Member
Back Marker
Joined: Dec 2017
Posts: 179
From: Quincy Mass
These are my Carb setupMain Jets Front 180
Rear 185
Needle Shims
Front .044
Rear .047
Pilot Jets 48
Air/ Mix Screw Front 2 ¼
Rear 2 ½
I had the Carbs Balanced on the vacuum ....but I will check that again. Never considered the valves too tight. I'll have to check that.
Rear 185
Needle Shims
Front .044
Rear .047
Pilot Jets 48
Air/ Mix Screw Front 2 ¼
Rear 2 ½
I had the Carbs Balanced on the vacuum ....but I will check that again. Never considered the valves too tight. I'll have to check that.
Thread
Thread Starter
Forum
Replies
Last Post
