04-07 CBR1000 Front Brake Lines ?
 

o.k i did some searching, 1000rr forks - 702mm long, vtr superhawk forks - 777mm long, & sp1 fork length is the same as superhawk fork length ?????????

I dont know if any of these measurments are correct !?

So if this is correct the 04-07 cbr1000 brake lines i would be guessing will be way too short.

Any help out there to confirm this would be a big help. Thanks.

Sorry I deleted my prev message and the measurements I took. On further inspection I believe the lines I have are off a 600rr, not a 1k. The calipers may be the same but I'm assuming the lines aren't as the aftermarket ones have different part #'s. How much the lengths differ I dont know. If you still want the 600rr measurements let me know. I'm sure someone on here has a 1000rr that could measure them for you.

I measured the stock CBR1000 brake lines that I just installed on my fork swap. From the MC to the right side fender mount were the lines split is 18", from that junction point 8" down to the right caliper.

when I put superbike bars on mine I used the 2inch additional length (that would be from the MC to the splitter if using a T-piece line). The splitter to caliper (unless using radial calipers) would be about the same. If using radial calipers the mount is lower and need an additional inch or so. With the 2 inch longer I have not had a problem with superbike bars or going back to clipons..

bc