Lets see if these pics upload.

 

What fender kit and turn signals did you use? Looks good. Not too hot on the clear taillight but overall looks clean and like you want it to.

 

Those look like the LP flush mount carbon/clear bullets and a regular rear fender bob.

I think the clear tail light looks great on his bike. My bikes red so it wouldn't go.

 

I used a razor knife and and clamped a straight edge on the fender, it came out really straight and even, I was prepared to buy an undertail but this turned out better than expected. I used lockhart phillips twin filament in the rear and have the extra filament hooked up to the brakes for extra visibility. I'm working on wiring up red l.e.d.s to put inside the signal so the brake light is red instead of yellow.

 

Whats that round cannister type thing on the front of your engine??

 

I would guess that is the lovely emmisions control charcoal canister for our friends in Cali...