I need a high mount exhaust bracket.
#1
I need a high mount exhaust bracket.
Hey guys and girls. Yesterday I found out upon looking at the bike that I broke one of my 2bros high mount exhaust brackets, the left one. Can't tell how I broke it but I know I did a ton of wheelies. I dunno if they still stock them, I doubt it but I was curious if anyone had any extra or if you guys know of any other bracket that will fit on there. Please let me know. Thanx
#3
alterntively, there are some stylized ones that crop up on eBay every so often, although I am not sure if they would be an exat fit (they are very similar to the ones that came with my Microns, however)
Good luck
Good luck
#7
That's cool you're getting another but if you still have the broken one, or all of it anyway, I could weld it for you-they're alum right? I recently started welding aluminum and it's not too hard. Let me know maybe I can help out.
#9
depending on where it broke, there is not much more than a 1/4" x 1/4" of material, welding it would make it hold for a few miles but I bet vibration would make it crack at that point
dont get too jealous guys, I am only giving him these brackets so I could get his address, now i can go be the new five finger own of that bad *** hawk
dont get too jealous guys, I am only giving him these brackets so I could get his address, now i can go be the new five finger own of that bad *** hawk
#11
Well, my quest continues as AC sent me a message believing that the brackets are not the right ones for the hawk. Anyone else has an idea which aftermarket brackets would fit? Thanx
Thread
Thread Starter
Forum
Replies
Last Post
AZZKIKER
Classifieds
0
10-18-2007 07:52 AM