cleaning out the garage
cleaning out the garage
ok fellow super-hawk enthusiast
I have decided to sell off the remaining super-hawk projects in my garage.
I have a 1998 black super-hawk with OEM FIRESTORM fuel-tank. The bike is set to look like a superbike with taller windscreen and brembo break and clutch stalks.
The bike was crashed and rebuilt, (not by me!!) and I purchased it with a broken motor bolt mount. The casting on the motor not the frame has broken away. This is the only issue I could find. I rode the bike and it pulled fine, shifted fine, did notice gritty neck bearings (I was going to replace anyway!)
Check out the pictures, the bike looks great, GPR high-mount exhaust system, has air intake system (forget the name? i'm sure someone can remind me) it does have a PA Rebuilt title.
to back this bike up I have a 90% complete second parts bike. This second bike is all apart!! parts as listed below
full frame w NJ title (front sub-frame mounts damaged)
new tank red paint OEM Honda
new clutch cover OEM Honda in the box
shift kit w gaskets
clutch New in box
motor swingarm and rear shock (suffered cct failure)
full rear subframe
full upper plastics w headlight
baskets of parts!!
seats, tail plastics,
ape CCT new X2
I know I am forgetting a lot of what I have!!
I'm looking to get 2200.00 for everything, really really want to make this easy and quick, however if you need one item please let me know, i will work with you!! I am also willing to deliver within 300+/- miles of 07843 for the cost of fuel (03 Tahoe at 15 MPG) in my enclosed trailer.
thanks to everyone
I have decided to sell off the remaining super-hawk projects in my garage.
I have a 1998 black super-hawk with OEM FIRESTORM fuel-tank. The bike is set to look like a superbike with taller windscreen and brembo break and clutch stalks.
The bike was crashed and rebuilt, (not by me!!) and I purchased it with a broken motor bolt mount. The casting on the motor not the frame has broken away. This is the only issue I could find. I rode the bike and it pulled fine, shifted fine, did notice gritty neck bearings (I was going to replace anyway!)
Check out the pictures, the bike looks great, GPR high-mount exhaust system, has air intake system (forget the name? i'm sure someone can remind me) it does have a PA Rebuilt title.
to back this bike up I have a 90% complete second parts bike. This second bike is all apart!! parts as listed below
full frame w NJ title (front sub-frame mounts damaged)
new tank red paint OEM Honda
new clutch cover OEM Honda in the box
shift kit w gaskets
clutch New in box
motor swingarm and rear shock (suffered cct failure)
full rear subframe
full upper plastics w headlight
baskets of parts!!
seats, tail plastics,
ape CCT new X2
I know I am forgetting a lot of what I have!!
I'm looking to get 2200.00 for everything, really really want to make this easy and quick, however if you need one item please let me know, i will work with you!! I am also willing to deliver within 300+/- miles of 07843 for the cost of fuel (03 Tahoe at 15 MPG) in my enclosed trailer.
thanks to everyone
Last edited by new2thehawk; Oct 11, 2015 at 05:46 PM. Reason: added information
Need clutch cover asap please!
Found a seat from another member. But really need that clutch cover, doing a water pump install and my cover has been all banged up from previous owner and leaks oil, not to mention I scored the **** outta where the water pump mechanical seal goes, trying to remove it.
lmk, I'm bout ready to just buy one new off partszilla $187.
lmk, I'm bout ready to just buy one new off partszilla $187.
Thread
Thread Starter
Forum
Replies
Last Post
calitoz
Classifieds
9
Aug 20, 2009 07:25 PM




