Cleaning out the garage
Thread Starter
Senior Member
Back Marker
Joined: Mar 2010
Posts: 233
From: Scottsdale , AZ
Cleaning out the garage
I have a few random engine parts that i would let go of cheap.
All parts are off a spare motor that had 40000 miles on it.
I have a good starter motor.
Oil pan
Shift drum
Rear cylinder head pipe
Sprocket cover
Oil pump pickup
Clutch pack and good pressure plate. The clutch plate thickness was measured and found at 3.8 mm which is the standard measurement according to the service manual. The service limit is 3.5 mm. The plates exceed the minimum thickness but they are used.
Water pump cover
I will sell any of these items for $10 each plus shipping or i will load them all up in one box and ship to you for $40 plus shipping.
PM me with any questions.
All parts are off a spare motor that had 40000 miles on it.
I have a good starter motor.
Oil pan
Shift drum
Rear cylinder head pipe
Sprocket cover
Oil pump pickup
Clutch pack and good pressure plate. The clutch plate thickness was measured and found at 3.8 mm which is the standard measurement according to the service manual. The service limit is 3.5 mm. The plates exceed the minimum thickness but they are used.
Water pump cover
I will sell any of these items for $10 each plus shipping or i will load them all up in one box and ship to you for $40 plus shipping.
PM me with any questions.
Last edited by motormouth; Feb 2, 2014 at 10:07 AM.
Thread
Thread Starter
Forum
Replies
Last Post
calitoz
Classifieds
9
Aug 20, 2009 07:25 PM
