Now all parts on ebay:
http://shop.ebay.com/chester_3000/m....&_trksid=p3686


Parting out an engine from a '98 hawk.
I got the bike with a seized engine.
I know nothing about the engine other than it had ~18,000 miles.
I tore the engine down to find the problem and discovered that the crank bearings had seized.
The cylinders and pistons have some scoring.
The crank probably needs to be reground.
The cases probably need to have the bearing races reground.

I'm also open to trades or trade+$$$ offers.

Thanks.



cylinder head covers -80ea (shipping varies.. ~10.00 ea)


clutch without clutch plates -SOLD



clutch rod lifter- SOLD


starter clutch- SOLD



oil strainer- SOLD


stator and stator cover- 180 shipped



right crank case cover- SOLD

front and rear camshafts -85 per set, shipped




cam chain tensioner guides- SOLD




pulse rotor, and (44T) gear and sub gear- SOLD



flywheel- SOLD




gear(76T/20T) and pin to starter clutch -SOLD





cylinder heads -alcohol leak down tested just fine -200 ea or 300 for both. shipping varies; ~15.00 ea





scored pistons (rings are almost brand new) -SOLD

transmission -160 shipped SOLD

oil pump with sprocket and chain - SOLD


crank case- some scoring in forward cylinder; would need re-honed. perfect if you're looking to get a big bore kit set up. lower case has scoring as well. 50 ea shipping varies; ~20.00 ea




crankshaft- in bad shape - 45 shipped obo



also have some misc. wires- 15ea shipped, obo

 

Pm'd on right cover

 

And sold to you!

 

Feel free to make offers.
I want this stuff gone.

These will be going up on ebay in the next few days....

 

Pm sent on flywheel.

 

Trans and oil pump sold to 1971allchaos
Thanks!

 

flywheel sold to Stumpy.
thanks

 

They are all now on ebay:
http://shop.ebay.com/chester_3000/m....&_trksid=p3686


Feel free to make low ball offers, as I rather these parts go to someone on here.
I'm happy to end the auctions early...

 

15 hours left....

 

Parts back up again on ebay:
http://shop.ebay.com/chester_3000/m....&_trksid=p3686

 

do you have the old CCTs, i am looking for a set to make manual ones out of. (basically i only need the cct housing)

 

Hey man would you be willing to part with just the stator cover? I don't need the stator.