CruxGNZ

I have searched and searched for this information. I found everything BUT what I needed.
It has to be somewhere, right?
I tried searching on here, the U.K. site and Google.
"VTR1000F rear axle dimmensions"
"Honda Superhawk rear axle dimmensions"
"Honda Superhawk rear axle size"
"Honda Superhawk rear axle bigness" (ya never know...)
Does anybody have the dimmensions for the rear axle?

I'm trying to figure out what I need to make my new wheels fit.
The RC Component wheels I have are:
Front wheel spacers I.D.: 22 mm (supposedly for a 2000 Yamaha R1)
Rear wheel spacers I.D.: 25 mm (supposedly for a RC51 either SP1 or SP2)

The '07 CBR1000RR forks I'm swapping to have, what I gather is, a 25 mm axle (I found front CBR1000RR bearings that are 25x47x12)

So, if I use the stock CBR1000RR front axle, I just need to get spacers made with a 25mm I.D.. Next step is finding somone competent who has a metal lathe around here.

Now, if I can figure out the Superhawk's rear axle dimmensions, then I can figure out how to fit the rear RC Component wheel.

rick

I thought I'd post here instead of a reply to your PM, so anyone searching can see this info

The VTR stock rear axle diameter is 20mm, length is 310mm.

The flanged spacer is 14mm wide and the other spacer is 13.5mm wide

Let me know if you need any other dimensions.

mikstr

if the rear wheel is from an RC51, do a search for a thread by a (former) member called mbuehler as he had fit a set of Oz RC51 wheels to his VTR. If you get it figured out, post the info as I may be looking at eventually fitting an aftermarket RC51 wheel on my bike too.....

CruxGNZ

Rick, you ROCK! That is exactly what I was looking for. Thank you very much! You just made this little project so much easier on me.

Mikstr, thank you for the heads up on the member mbuehler. I will make sure to post the info here. Just found out that I have no work all next week, so it looks like I'll be working on fitting these wheels sooner than I thought. Stay tuned

hondavtr1000sp2