Front flushmount led turn signals wont blink.
 

Hey guys, new to forum, but ive been skimming your sight for great technical info lol. Thanxs btw.
So i have a 2005 Super hawk. Bought some nice smoke led flushmount lights for $7 from china (Dont knock the purchase its the same as buying it at a store but 3 times less) Look great, fit nice BUT when i plugged them in (orange w / stripe is positive right?) It lights up but when u put the turn signal on for left turn it turns off. I have the two wires connected but thres no grounding wire on it, just 2 wires. Cant figure it out... i switched wires and wont light up at all, only 2 possible solutions right? I just covered ground wire with electrical tape and plugged the orange stripe w / yellow wire positvie. Lil help guys. Didnt have this problem with my 98 S hawk... thanks

it sounds like you hooked up the running lights the first time as the oem lights have 3 connectors each i have the same kind of setup on mine but i cant remember the wire configuration off the top of my head but if you have a manual it will tell you the wire config.

3 wire turn signals to 2 wire LED lights - Honda Motorcycles - FireBlades.org

Think i got it! Ground is critical in connection, gonna go check it out, cant sleep till this is done!

Woohoo got it! Yellow goes with hard orange, green ground goes with black, and cap off orange n white stripe wire!! Same for right side blue with yellow, black with green ground, and cap off blue n white stripe! Booyaa

great stuff thanks for the info

Need pics and link to the site. I want some....

You can have turns and running lights if you install a diode as per the tutorial. More lights the better.