Cheap ignition advancer idea??
Hi, i was just thinking how to make a cheap advancer and i think i got it.
Can`t i just remove the teeth from the OEM advancer plate so it can freely rotate(when not tightened the holding bolt). So i can adjust it in the position i like , may put samo marks ot it to scale the degrees advance. Rotate it to 4 degrees, tighten the bolt and there you have it - cheap adjustable advancer:D I am just not sure it will not loose position during rotation. Any opinions?? (a OEM plate is less than 10$ so i may give it a try) |
The first question would be,what year bike do you have?
The advancers only work with the early model ECU, so if you have a 2001 or later, an advancer will not work for you. Second, I personally do not think your idea will work out. You will be shooting for 4 degrees of advance and setting it along with holding it in place while tightening and\or running might not work out so well. If you have to try and modify a stock advancer, I would work on the splines in the center of it. Work out how much material to remove from each tooth to get the 4 degrees of advance and then you would be able to hold it in position while tightening it. Either way, it will be a lot of work and you can pick one up pretty cheap if you look around. |
It is 98 bike(probably) 97.
If i draw a scale on it showing the degrees it must not be soo hard. And machinig the teeth is too much work. How cheap i can get one? I got once FP adjustble for my katana fo 20$:evillaugh: |
All times are GMT -7. The time now is 09:01 PM. |
© 2024 MH Sub I, LLC dba Internet Brands