Axle Bobbins / Sliders
12-03-2007, 08:13 PM
#1
Senior Member
SuperSport
Thread Starter
Join Date: Aug 2007
Location: Fredericksburg, VA
Posts: 714
Axle Bobbins / Sliders
Anyone ever try fitting some axle sliders on the Hawk? I just figured out how they work with a long bolt going through the axle and the sliders on each end. I wonder which model would be compatible?
They might not protrude enough to offer any protection though since the pipes and passenger pegs stick out so far on both sides.
They might not protrude enough to offer any protection though since the pipes and passenger pegs stick out so far on both sides.
12-03-2007, 08:18 PM
#2
Senior Member
SuperBike
Join Date: Jul 2004
Posts: 1,015
Anyone ever try fitting some axle sliders on the Hawk? I just figured out how they work with a long bolt going through the axle and the sliders on each end. I wonder which model would be compatible?
They might not protrude enough to offer any protection though since the pipes and passenger pegs stick out so far on both sides.
They might not protrude enough to offer any protection though since the pipes and passenger pegs stick out so far on both sides.
I use them on my SuperMoto and they do work....
Some SuperMoto guys use a small set of Skate Board wheels and a threaded rod of course with nice nut hardware
12-03-2007, 08:22 PM
#3
Senior Member
SuperSport
Thread Starter
Join Date: Aug 2007
Location: Fredericksburg, VA
Posts: 714
Thats a good idea. Maybe I'll take some measurements next spring when I ride again. I'm DUN til it gets warm again. I have always ridden in the cold, rain, and cold and rain, til I wrecked pulling out of a parking lot with cold tires and spun around to the ground. Time to pull it apart and paint it. Maybe I'll look into a cage.
Thread
Thread Starter
Forum
Replies
Last Post
